Inquiry
Form loading...

Cleaning method for outer half tube heating reaction kettle

2024-06-28

The cleaning and electric heating cleaning of the outer disc half tube heating stainless steel reactor are commonly used methods for impurity removal, mainly using equipment with a circulation pump. Some cleaning agents, stirring, and high-temperature radiation are added to the reactor. The correct cleaning method not only ensures quality but also improves efficiency, but many customers choose not to do any cleaning.

 

For a long time, the outer disc half tube heating stainless steel reactor has accumulated a large amount of impurities, which not only affects the service life of the reactor, but also affects the efficiency of the reactor. The reactor should be cleaned immediately before discharge. Install the reaction valve from the exhaust valve into the kettle, and after cleaning most of the residue, inject water and stir for about ten minutes. At this time, the kettle can be opened and the inner wall of the kettle can be cleaned.

 

The outer plate half tube heating stainless steel reaction kettle needs to be cleaned by cleaning the kettle cover and sampling valve, and at the same time, a small amount of nitrogen should be taken under the water conditions inside the kettle; Not currently in use. Add 70% anhydrous ethanol and anhydrous ethanol to the non reaction vessel. A stainless steel reactor is an equipment used to process liquids and some highly corrosive liquids and objects. After a period of use, it is necessary to remove its own impurities to ensure that the equipment is not corroded by impurities.

 

The production process of the outer disc half tube heating stainless steel reactor mainly adopts variable frequency speed regulation. During use, different speeds can be selected according to its different processes and viscosity. The inner wall of the stainless steel reactor is finely processed by a large vertical lathe, which ensures that the movable scraper can completely scrape off the materials on the inner wall and bottom of the stainless steel reactor when rotating.

 

There are two sets of high-speed dispersion axis dispersers in the outer plate half tube heating stainless steel reactor, which will cause various materials to be strongly sheared and dispersed during operation; The inner coil of the jacket can achieve cooling. The frame type mixer in the middle is equipped with a scraping shaft, which can scrape the wall while stirring. To achieve better mixing effect of materials.

 

The electronic components of the stirring control circuit of the outer disc half tube heating stainless steel reactor are assembled on a single circuit board to a certain extent. During operation, its double closed loop control system is mainly used, which has the characteristics of high speed regulation accuracy, stable speed, strong anti-interference ability, and has complete protection functions such as limiting and overcurrent.